Red Epic DSMC MEDIA Operation Manual
Also see for DSMC MEDIA: Operation guide
                                                                                | |
Contents
| 
R E D D S M C M E D I A O P E R AT I O N G U I D ECOPYRIGHT © 2014 RED.COM, INC 955-0047, REV-F | 494. Reconnect the SSD module to the camera and install the SSD.5. Power up the camera.6. Ensure that the SSD is recognized; reformat the SSD if necessary.7. Resume recording.NOTE: DO NOT remove the SSD while the camera is recording.NOTE: If the problem persists, try recording with another SSD.MEDIA DOES NOT MOUNT TO CAMERASYMPTOMMedia does not mount to your DSMC.POTENTIAL RESOLUTIONS Reformat the SSD on the computer. For more information about formatting media on the computer, go to“Format (Erase) Media Via Computer” on page 38. Perform a system restore, and then remove and reattach the media module. Use an alternate media module. Use an alternate DSMC.WARNING: If the problem persists after reformatting the SSD and attempting to mount the SSD on an alternateDSMC, the SSD is likely damaged or otherwise compromised. DO NOT attempt to record to an SSD that is ex-periencing these problems. Any footage that is recorded to the SSD may be lost, damaged, or unrecoverable.MEDIA DOES NOT MOUNT TO COMPUTERSYMPTOMMedia does not mount to your computer via a RED STATION RED MINI-MAG, RED STATION REDMAG 1.8",RED STATION REDMAG 1.8" (MINI), or RED STATION REDMAG 2.5".POTENTIAL RESOLUTIONS Ensure that the SSD is pushed all the way into the RED STATION until you feel it hit the back. Turn the RED STATION off and on using the On/Off Switch on the rear panel of the RED STATION. Disconnect and reconnect all cables. Use an alternate data cable or data connection. Use an alternate power cable. Use an alternate port on your computer. Use an alternate computer. If connecting to your computer via eSATA, ensure that the RED STATION is powered via the RED STATIONAC POWER ADAPTOR or the RED STATION USB TO DC POWER CABLE (24"). If connecting a RED STATION REDMAG 1.8" (MINI) with a 48GB or 512GB REDMAG 1.8" SSD via a USB2.0 or USB 3.0 connection, ensure that the RED STATION REDMAG 1.8" (MINI) is powered via the REDSTATION AC POWER ADAPTOR or the RED STATION USB TO DC POWER CABLE (24"). If there are no clips on the SSD, connect the SSD to the camera and reformat the SSD. For more informa-tion about formatting media, go to “Format (Erase) Media In-Camera” on page 36. If using a Mac, the SSD may be recognized by the computer but not mounted. Launch the Disk Utility ap-plication, select the SSD in the left panel, and click Mount in the toolbar. |
Related manuals for Red Epic DSMC MEDIA
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine