Working With Your Virtual Systems185TipYou may receive the following message from the Kickstart Status page duringthe guest's kickstart:The install process on the guest system has not communicated to RHN inthe past n minutes. This may be due to a hung install process, or itmay just be due to a slow install because of hardware constraints. Alog of the installation process is available, you may wish to reviewit to troubleshoot this issue.Be patient and do not worry if you see this message unless more than twenty minuteshave passed. To check if the kickstart is continuing, check the installation log to makesure there are no errors, and as you reload the Kickstart Status page check to seethat the Last File Request field continues to be updated.4. If you would like to register additional guests to your host, repeat the steps above. It is importantto remember that you can only provision one guest at a time. If you attempt to schedule a guestkickstart while another is currently taking place, the current guest kickstart process will becanceled and the new guest kickstart process will begin.5. View your newly-created virtual guest's system in the Satellite's web interface by clicking onthe Virtualization tab in the host system's profile. Then, click on the profile name of your virtualsystem. You will be brought to its Satellite system profile.10.3. Working With Your Virtual SystemsOnce you have set up your virtual system, you can then manage and customize them via variousmethods, including connecting via SSH and via the virtualization management interface on the hostsystem.10.3.1. Logging into Virtual Systems Directly via SSH1. You will need to locate the virtual system's IP address. Locate it by navigating to the Systems Virtual Systems tab and clicking on the virtual system's profile name.2. On the virtual system's profile page, you'll find the IP address in the left-hand informational columnin the IP Address field.3. Connect to the IP address by using ssh as root, using the password you set for the virtual systemin the kickstart profile you created for it earlier.10.3.2. Gaining Console Access Via the Host1. First you will need to connect to the host system and determine the ID number of the guest youwould like to work with. Connect to the host system via ssh and run the following command:xm list
