RedMax BC2200E Owner's/operator's Manual

Contents

■ HE2200LDC1. Install the blade guard to the gear case withthe provided 3 screws.2. Place the blade between the cutter holders(A) and (B) while locking the gear shaft byputting the bar , one of the tools provided,through the key holes on the holder(A) andthe gearcase. Use the socket and the baras shown in the picture below to tighten themounting nut.3. Install the J-shaped handle to the shaft tubeand clamp at a position best for your job.• ADJUSTING HANDLE POSITIONLoosen the handle bracket screws andreposition the handle to your best operatingposition. Re-tighten the screws.1. Install the driveshaft assembly to the engineunit. Clamp it securely with the attachedbolt and nut.2. Connect the throttle cable to the engine.3. Mount the handle to the driveshaft casingand clamp it at a position suitable foroperation.4. Install the debris guard to the bracket withscrews provided.SETUPBT2200LDCAttach the guard above the clamp and slideit down. Rotate it a half turn to set in place.BC2200EBC2200LDCHE2200LDC 3 