11 Set up■ HT22001. Join the engine unit to the clutch housingof the cutter unit, with the fuel tank on theblade side.2. Align the mounting holes and tighten theengine securely with the 3 screws.3. Remove the right handle mounting screw,nut, and washer casually attached on theblade beam.4. Set the right handle on the beam makingthe grip come to the opposite side of thecutting teeth, and attach with the hardwareremoved before. When fastening the nut,hold the screw to keep the blade washerloose.• To assure designed cutting performance,always keep a half spare turn for the bladescrews. Over tightening will cause bladeseizure and premature wear of the clutchsystem. Too loose screws will make thegap between the blades large, and result inpoor cutting performance.NOTE5. Install the left handle to the bracketattached to the clutch housing. Use thehardware as shown below.7. Cover the throttle cable with colgate tube.Connect the throttle cable and the switchwire. Hold the wires at the lower part ofthe handle using the tie band.8. Check the cable play and, if necessary,adjust between .04” and .08” by bendingthrottle wire receiver of the bracket withneedle nose pliers.BLADE WASHER(Keep Loose)