Redpine Signals, Inc. Proprietary and confidential Page 19RRSS99111100--NN--1111--2222//2244//2266//2288 –– SSeellff--CCoonnttaaiinneedd WWLLAANNMMoodduulleess wwiitthh NNeettwwoorrkkiinngg SSttaacckkFigure 11: Creating a IBSS NetworkNOTE: The present firmware requires that the module be powered offand on if a connection to a different BSS is required. After powering onthe module, the same steps are to be followed as before.2.3: IP Address ConfigurationThe RS9110-N-11-2X has an inbuilt TCP(UDP)/IP stack and thus provides anoption for the Host to transmit only application data, which is transmitted overWLAN after TCP/UDP packetization.The TCP/IP stack has to be configured with the IP Address, Subnet Mask andGateway Address.The Configuration can be done in two ways:1. Manual2. DHCP2.3.1: Manual ConfigurationThe user has to perform the steps below to configure the IP parameters.1. Select the Manual Mode from the configuration utility.2. Enter the IP Address in the dotted decimal format.
