Reer MOSAIC Master M1 Installation And Use Manual

Also see for MOSAIC Master M1: Installation and use Installation and use manual Installation and use Installation and use Installation and use

Contents

Reer MOSAIC Master M1 Installation And Use Manual Manual pdf 92 page image

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC92 8540780 • 30/03/2016 • Rev.26english Two output test signals are mandatory. Each output OUT TEST can be connected toonly one input S-MAT (it is not allowed parallel connection of 2 inputs). The function block S-MAT can not be used with 2-wire components and terminationresistance.Output test: This is used to select which test output signals are to be sent to the s-matcontact. This additional control permits detection and management of any short-circuitsbetween the lines. To enable this control, the test output signals must be configured(amongst those available). Test signals are mandatory.Test at start-up: If selected this enables the test at start-up of the external component.This test is performed by pressing and releasing the safety mat to run a completefunction test and enable the output. This test is only requested at machine start-up (whenthe unit is switched on).Filter (ms): This is used to filter the signals coming from the external contacts. The filtercan be configured to between 3 and 250 ms and eliminates any bouncing on thecontacts. The length of the filter affects the calculation of the unit's total response time.Enable Error Out: If selected reports a fault detected by the function block.Item description: This allows a description of the component's function to be entered. Thetext is displayed in the top part of the symbol.SWITCH function block verifies the input statusof a pushbutton or switch (NOT SAFETYSWITCHES). If the pushbutton is pressed theoutput is 1 (TRUE). Otherwise, the output is 0(FALSE).ParametersManual reset: If selected this enables the requestto reset each time the device is activated.Otherwise, enabling of the output directly followsthe input conditions.There are two types of reset: Manual andMonitored. When Manual is selected the systemonly verifies the signal's transition from 0 to 1.If Monitored is selected the double transition from 0 to 1 and then back to 0 is verified.t = 250mst1 > 250mst2 = 250ms WARNING: If the Manual Reset is active, a consecutive Input have to be used.Example : Input 1 is used for the fuctional block, then Input 2 have to be used forthe Reset Input.