Regency E18-NG Owners & Installation Manual

Also see for E18-LP: Owners & installation manual Manual

Regency E18-NG Owners & Installation Manual Manual pdf 44 page image

44 Regency ® E18 Gas Fireplace InsertINSTALLATIONSTEP #4: SURROUND INSTALLATION1. Remove glass door from unit (see instructions in manual).2. Remove control box from rear surround by removing 2 screws.Disassemble control box, insert switches; reassemble.3. Remove left mounting bracket by removing 3 screws.Control Box Rear surround4. Run wire from unit through notch in mounting bracket and thento control box as shown below.5. Attach control box to left mounting bracket with 2 screws - reat-tach mounting bracket.6. Tuck wire harness on left top groove and secure with wire clips.7. Feed power cord through left grommet. (If power outlet is onthe right side of the unit, feed power cord through right grom-met and use wire clips to secure power cord inside the unit).8. Secure backing plate with mounting brackets to outer box byscrewing 4 self tapping screws on fl anges.10. Reinstall glass door (see instructions in manual).11. Install control cover, adjust horizontal alignment by slidingcontrol cover to ensure even spacing on both sides. Ensurecontrol cover is seated down all the way.9. Attach front faceplate with 4 screws (2 on each mountingbracket). (Touch up screws with provided black paint, afterinstall.)Notch inmountingbracketDiagram 10.5Diagram 10.6Diagram 10.7Diagram 10.8Diagram 10.9Diagram 10.10ONLY TRIM KIT SUPPLIED BY THE MANUFACTURER SHALL BEUSED IN THE INSTALLATION OF THIS APPLIANCE.DRAFT RELIEF OPENINGS MUST NOT BE COVERED OR BLOCKED.