Regency E18-NG Owners & Installation Manual

Also see for E18-LP: Owners & installation manual Manual

Regency E18-NG Owners & Installation Manual Manual pdf 45 page image

Regency® E18 Gas Fireplace Insert 45INSTALLATIONREMOTE CONTROL INSTALLATIONRemote controls approved for use with this appliance:Part # Remote Function910-368 Basic Remote ON/OFF910-399 Firegenie Remote ON/OFF + 7 day programmablethermostat946-680 GT Profl ame Remote ON/OFF + Thermostat controlNOTE: Remove bottom control panel on the surround prior to installingthe remote control.1. S hut off gas and electrical supply, allow unit to cool to room temperature.2. If using the GT Profl ame remote control, attach the wire labeledreceiver from the wiring harness to the back side of the remotereceiver. See Diagram 1 below.Diagram 1Diagram 4—cut female wire spadeDiagram 5Diagram 6Diagram 3 - Red TH wire disconnectedDiagram 2—Receiver in position3. Install remote receiver (from any of the approved remote controls)on the far right hand side of the unit. See Diagram 2 (Basic Remotereceiver shown).4. Disconnect red wire from TH terminal on valve - see Diagram 3.5. Cut the female wire spade from the disconnected red wire at the endof connector see Diagram 4.Bare the same red wire using wire strippers in order to connect newmale connector, see Diagram 4.5a. Crimp on new male connector wire using a crimping tool, see Diagram 5.6a. Basic or FireGenie remote: Attach one of the two black wires fromthe remote receiver and connect it to the red wire disconnected inthe previous steps, see Diagram 5.6b. GT remote control: Attach the white wire from the wiring harnesslabeled TP/TH and connect it to the red wire disconnected in theprevious steps, see Diagram 6.Receiver wire harnessGT remoteFemale wire spadeStrip wire—add maleconnectorReceiver