Regency E21-NG10 Owners & Installation Manual

Regency E21-NG10 Owners & Installation Manual Manual pdf 13 page image

Regency ® E21-10 Gas Fireplace Insert | 13|13installationWIRING DIAGRAMSCAUTION: Label all wires priorto disconnection when servicingcontrols. Wiring errors cancause improper and dangerousoperation.WARNING: Electrical GroundingInstructionsThis appliance is equipped with athree pronged (grounding) plug foryour protection against shock hazardand should be plugged directly intoa properly grounded three-prongreceptacle. Do not cut or remove thegrounding prong from this plug.This heater does not require a 120V A.C. supplyfor operation. In case of a power failure, theburner switch and the optional remote control/thermostat will continue to operate. However, a120V A.C. power supply is needed for the fan/blower operation.Caution: Ensure that the wires donot touch any hot surfaces and areaway from sharp edges.When connected with 120 volts, the appliancemust be electrically grounded in accordancewith local codes or, in the absence of localcodes the current CSA C22.1 (in Canada) orwith the National Electrical Code ANSI/NFPA70-1987 (in USA).NOTE: This unit is equipped with a heatsensor thermodisc which willprevent the blower from operatinguntil the unit reaches the correcttemperature.Flue Spill Switch(Auto Reset)ENGLISHREMOTETPTHTPTH GreenWhiteRedBlack(+) (-)9GroundNeutralLiveBlackBlackRedMinimum ConvectionAir Temp. SwitchON OFFRotary SpeedControl120V AC60 HzGreenGroundFanLockwasherFangroundPowercordgroundwireStarwasherNutNut#8 Ground LugStarwasherDCSpark BoxToElectrodeToElectrodeThermostat(Optional)(Millivolt)RedRed