Regency E21-NG10 Owners & Installation Manual

Regency E21-NG10 Owners & Installation Manual Manual pdf 23 page image

Regency ® E21-10 Gas Fireplace Insert | 23|23installation1 11.05.14919-462E21-102. Attach the faceplate backing and spacer if installed to the insertbody using 4 screws in as shown in Diagrams 2 and 3.1. A spacer is supplied and may be installed if required to extend thedepth of the faceplate by 1-3/4". Install the spacer onto the backside of the faceplate backing with 8 screws in locations shownbelow (3 on each side to secure spacer to faceplate backing and2 to secure the top piece - spacer only).Diagram 2Diagram 3Diagram 4Diagram 5Diagram 6Diagram 7Receiver Faceplate backingLow profile faceplate installation2. Connect the male end black and red fan switch wires (in theblack casing) to the wire connectors from the fan speed control.5. Secure the wires to the back of the inner faceplate with a wire clip.6. Ensure batteries are installed into receiver then Install receiver(packed with manual) on the right side of the faceplate backing -connect 12 pin connector to receiver from wiring harness (markedreceiver).3. Tuck the wires into the clip to keep them away from the insert usingthe clip provided. Attach the clip to the rear of the faceplate to en-sure that the wires do not touch the side of the unit. The power cordshould be run behind the inner faceplate panel.4. Install the fan speed control box to the left hand bottom leg of theinner faceplate. Controls located on the left side. One screw at top(as shown) and one at the bottom.Diagram 1LOW PROFILE FACEPLATE INSTALLATION