Regency Horizon HZ30E-NG10 Owners & Installation Manual

Also see for Horizon HZ30E: Owners & installation manual Owners & installation manual

Regency Horizon HZ30E-10 Gas Fireplace | 9|9installationThis includes:1. Clocking the appliance to ensure the correctfiring rate (rate noted on label 14,000 Btu/h(NG), 13,000 Btu/h (LP) after burning appliancefor 15 minutes.2. If required, adjusting the primary air to ensurethat the flame does not carbon. First allow theunit to burn for 15-20 min. to stabilize.CAUTION: Any alteration to the product thatcauses sooting or carboning that results in dam-age is not the responsibility of the manufacturer.INSTALLATIONCHECKLIST1. Locate appliancea) Room location (Refer to "Locating Your Gasfireplace" section)b) Clearances to Combustibles (Refer to"Clearances" section)c) Mantle Clearances (Refer to "MantelClearances" section)d) Framing & Finishing Requirements (Referto "Framing & Finishing" section)e) Venting Requirements (Refer to "Venting"section)2. Position nailing strips (Refer to "Unit AssemblyPrior to Installation).3. Slide unit into place.4. Remove installation access panel.5. Install vent (Refer to "Venting Arrangement"sections).6. Make gas connections (Refer to "Gas LineInstallation section).7. Make electrical connections to receptaclesupplied with unit (recommended).8. Install 4 AA batteries into receiver/switch boxor use AC power adaptor supplied with unit.9. See remote control instructions for operationof this device.10. Test the pilot (Refer to "Pilot Adjustment"section).11. Test Gas Pressure (Refer to "Gas Pipe PressureTesting" section).12. Install standard and optional features. Refer tothe following sections:a) Glass Crystals/ Optional CeramicStonesb) Optional Firebox Base Pebblesc) Optional Reflective Panelsd) Optional Fane) Faceplate13. Reinstall installation access panel.14. Final check.Before leaving this unit with the customer, theinstaller must ensure that the appliance is firingcorrectly and operation fully explained tocustomer.LOCATING YOURGAS FIREPLACE1. When selecting a location for your fireplace,ensure that the clearances are met.2. The appliance must be installed on a flat, solid,continuous surface For example a wood, metalor concrete floor or in a raised (on the wall) ap-plication. The appliance must be installed ona metal or wood panel extending the full widthand depth of the appliance.3. The HZ30E Direct Vent Gas Fireplace can beinstalled in a recessed position or framed outinto the room as in A, B, C and D.See Diagram 1.Diagram 1A) Flat on WallB) Flat on Wall CornerC) Recessed into Wall/AlcoveD) Corner4. This appliance is Listed for bedroominstallations using the standard Remote(millivolt thermostat system). Some areas mayhave further requirements, check local codesbefore installation.5. The HZ30E Direct Vent Gas Fireplaceis approved for alcove installations, see"Clearances" section for details.6. We recommend that you plan your installationon paper using exact measurements forclearances and floor protection before actuallyinstalling this appliance. Have an authorizedinspector, dealer, or installer review your plansbefore installation.Note: For vent terminations refer to "ExteriorVent Termination Locations" section.