Regency LRI4E Owners & Installation Manual

Also see for Liberty LRI4E series: Owners & installation manual Owners & installation manual

Contents

LRI4E / HRI4E Direct Vent Gas Insert | 23|23installation919-350a 07/30/14Ensure unit is cooled to room temperature and remove glass door.1. HRI4E Unit only.Remove burner (see manual for instructions).Remove existing pilot shield by removing 2 screws.Install pilot shield provided with Log Set using 2 screws fromprevious pilot shield. Reinstall burner.Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,Note: This Log installation is for NG units only.1 Rear Centre Log2 Centre Right Front Angled Log Piece3 Right Forked Upright Log4 Left Angled Upright Log5 Left Angled Cross Log6 Right Front Angled Log Piece7 Centre Left Front Angled Log PieceRear Log Bracket (HRI6E/HRI4E units)Pilot shield (HRI4E units only)Lava Rock and Embers1234 765129-1/4"123. Place Log 1 on Rear Log Bracket, ensure Log is centered. Placesmall amount of glass crystals on pilot cover, over top pilot area infront of Log 1.4. Place Log 2 on the glass, angled with the non charred point of theLog is approximately 9-1/4" from the right side of the burner tray.Glass quantities with Log installationHRI4E 5 lbsHRI6E 6 lbsNote: If glass previously installed - remove 2lbs to equal above quantity.2. Both HRI4E & HRI6E Units.Sweep glass aside (if already installed) to install Rear Log Bracket,clip the front edge of the rear bracket on to rear of the burner asshown below.Rear Log BracketCenter Log 1 on bracketPosition Log 2New Pilot Shield - HRI4E Only1HRI6E / HRI4EOPTIONAL LOG SET INSTALLATIONHRI4E OPTIONAL LOG SET INSTALLATION