Regency P121 Owners & Installation Manual

Also see for P121LC: Owners & installation manual Owners & installation manual Owners & installation manual

Contents

Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace2To the New Owner:Congratulations!You are the owner of a state-of-the-art Gas Fireplace by REGENCY®. The P121 / P121LC / P121RC / P131is a hand crafted appliance and has been designed to provide you with all the warmth and charm of a woodfi replace at the fl ick of a switch. The model P121 / P121LC / P121RC / P131 has been approved by Intertekfor both safety and effi ciency. As it also bears our own mark, it promises to provide you with economy,comfort and security for many trouble free years to follow. Please take a moment now to acquaint yourselfwith these instructions and the many features of your Regency ® Fireplace.IMPORTANT: If the unit is to be installed into a bathroom, optional Neo ceramic glass Part# 360-946 Frontor Part# 360-948 Side must be purchased and installed in place of the tempered glass supplied with theunit.MANUFACTURED MOBILE HOME REQUIREMENTSINFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALEThis Regency ® product has been tested and listed by Intertek as a Direct Vent Wall Furnace to the following standards: VENTEDGAS FIREPLACE HEATERS ANSI Z21.88a-2000/CSA 2.33a-2000 and GAS-FIRED APPLIANCES FOR USE AT HIGH ALTITUDESCAN/CGA 2.17-M91.This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and theManufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or the current Standard of Fire Safety Criteria forManufactured Home Installations, Sites, and Communities ANSI/NFPA 501A, and with CAN/CSA Z240-MH Mobile Home Standardin Canada.This appliance installation must comply with the manufacturer's installation instructions and local codes, if any. In the absence oflocal codes follow the current National Fuel Gas Code, ANSI Z223.1 and the current National Electrical Code ANSI/NFPA 70 in theU.S.A., and the current CAN/CGA B149 Gas Installation Code and the current Canadian Electrical Code CSA C22.1 in Canada.This Regency ® mobile/manufactured home listed appliance comes factory equipped with four 1/4" diameter holes located near eachcorner of the base. Fasten the fi replace in place using screw, inserted through the holes.This appliance comes equipped with a dedicated #8 Ground Lug for attachment of the ground wire to the steel chassis as applicableto local codes. See the "Wiring Diagram" section.The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, withthe National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.This appliance may only be installed in an aftermarket permanently located, manufactured (U.S.A only) or mobile home, where notprohibited by local codes.This appliance can only be used with the type of gas indicated on the rating plate. This appliance is not convertible for use withother cases, unless a certifi ed kit is used.Ensure that structural members are not cut or weakened during installation.