Regency P121 Owners & Installation Manual

Also see for P121LC: Owners & installation manual Owners & installation manual Owners & installation manual

Contents

Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace 2724) Locate the ground lug at the recepticalbox, left of the unit.Installer Notice:These instructions must be leftwith the appliance.25) Connect one end of the supplied greenground wire to the lug with the nut andwasher from the kit.26) Install the 1/2" bushing to the heat shield.Groundwire fromkit28) Plug the DC spark generator wires to theDC Sparker.29) Connect the ground wire to the DCSparker mounting bracket.31) Mount the heat shield to the DC Sparker.Secure into place with the velcro, which isprovided in the kit.33) Tie up the loose wire with the wire clip.Heat Shield27) Run the other end of the ground wire andDC spark generator wires through thebushing on the heat shield.32) Find a location which is not too hot and iseasy to reach for changing thebattery.34) Check for gas leaks.35) Check inlet and outlet pressures.36) Check operation of flame control.37) Check for proper flame appearance andglow on logs.30) Install the supplied battery into the DC SparkerBox by opening the battery compartment.NOTE: The battery in the DC Sparker Boxwill need to be replaced annually.BatteryCompartmentINSTALLATION