Regency P33-LP3 Owners & Installation Manual

Regency P33-3 Zero Clearance Direct Vent Gas FireplaceINSTALLATIONNote: The logs must not be in the unit.3) Insert the back brick panel by carefully slip-ping it between the back wall of the fireboxand the rear log bracket.OPTIONAL BRICKPANELS1) Undo the bottom 2 door latches and openand remove glass door. Remove logs.2) Attach the 2 Rear Brick Retaining clips tothe rear wall. Loosen the screws in the topand rear wall of the firebox and slide theretaining clips into position (tight against thefirebox top) and then tighten the screws.4) Put the side panels in next. Slide them infrom the front and push them flat up againstthe wall. Be very careful not to scratch themon the firebox hardware.5) Slide the Top Brick Panel into position andslide the Top Brick Retaining clips so thatthey hold the Top Brick Panel in place andtighten down the screws.LOG SET INSTALLATIONNOTE: If you will be installing the optionalBrick Panels, install the Brick Panelsprior to installing the logs.1) Carefully remove the logs from the box andunwrap them. The logs are fragile, handlewith care - do not force into position.2) Sprinkle the vermiculite and embers aroundthe firebox base.NotchBracketBracket250254Vermiculite Vermiculite Vermiculite250254The 3-digit numbers (i.e. 250) aremolded into the rear of each log.Read the instructions below carefullyand refer to the diagrams. If logsare broken do not use the unit untilthey are replaced. Broken logs caninterfere with the pilot operation.Log Kit # 431-930 contains the fol-lowing pieces:A) 250 Rear Log 902-250B) 254 Middle Cross Log 902-254C) 253 Front Left Cross Log 902-253D) 251 Rear Left Log 902-251E) 252 Front Right Cross Log 902-252F) Embers 902-156G) Vermiculite 902-179/21H) Rockwool 902-1533) Place the Log 250 on the rear log supportpins with the flat side to the back.4) Place Log 254 on the front right side of theburner. Push the back of the log against the2 brackets with the notch on the bottom rightside of the log fitting into the right side ofthe grate.5) Position Log 253 across the cutouts in Logs250 and 254 with the notch on the left sideof the log fitting into the 2nd grate tab.Cutouts2nd Grate Tab253250254D) 251 A) 250C) 253 B) 254 E) 252