Regency P36-NG5 Owners & Installation Manual

Regency P36-NG5 Owners & Installation Manual Manual pdf 23 page image

Regency ® P36-5 Gas Log Fireplace 23STANDARD FLUSH DOORDiagram 3Use the hook to pull the spring out until youcan put the hook into the slot on the bottomdoor bracket. Repeat for 2nd spring. Seediagram 3.Diagram 2The standard flush door comes with a blackframe. To install the frame, simply hook the topdoor flange onto the top of the unit and swingthe door towards the unit, diagram 1.Be careful that the glass gasket does not roll up;there must be a gap between the gasket andthe door lip to ensure that the door sits securelyon the unit. Diagram 2.Diagram 1 To remove the flush door, reverse the abovesteps.OptionalFlush TrimAttach the roundmagnets to theback of the top trimpiece and to thebottom trim piece,then attach trim tothe top and bottomof Flush door.Flush Louvres / PremiumFlush Front1) Install the top louvre by sliding the twobracket clips into the brackets locatedunderneath the top of the firebox.2) The bottom louvre has a hinge that isattached (2 screws per hinge) to the lip onbottom of the unit.Note: Top and bottom louvres aredifferent.10) Place the embers on the front of the burnertray in the places shown on the photo.11) Test fire to ensure proper light off (make sure flame flows smoothly from one end of burnerto the other). If there is any flame hesitation, check that area for any blockage of the burnerports.Place embers in these 3 locationson the burner tray.Embers02-5002-5502-4902-53 02-5102-5402-52INSTALLATIONNote: If the optional premium flushfront is used, the fan must run atminimum speed to prevent the unitfrom over heating. Over heating willcause automatic shutdown via thethermodisc safety switch.