Regency P42 Owners & Installation Manual

Also see for Gas Fireplace P42-LP4: Owners & installation manual

Regency P42 Owners & Installation Manual Manual pdf 36 page image

Regency ® P42-4 Zero Clearance Direct Vent Gas Fireplace 35COPY OF THE LIGHTING PLATE INSTRUCTIONSOPERATING INSTRUCTIONS1) Push in gas control knob slightly and turn to “PILOT” position.2) Push in control knob all the way and hold in untilthe pilot lightsup. Continue to hold the control knob in for about 20 secondsafter the pilot is lit. Release knob.3) Push in gas control knob slightly and turn to "ON" position.4) Turn ON the flame switch.2) Wait five (5) minutes to clear out any gas. If you then smell gasSTOP! follow “B” in the safety information above on this label. Ifyou don’t smell gas, go to the next step.3) Tu rn knob on gas control counterclockwise to “PILOT”.4) Pu sh in control knob all the way and hold in. Immediately pushblack button on spark igniter until pilot lights. Continue to hold thecontrol knob in for about 1/2 minute after the pilot is lit. Releaseknob and it will pop back up. Pilot should remain lit. If it goes out,repeat steps 3) and 4).If knob does not pop up when released, stop and immediately callyour service technician or gas supplier.If the pilot will not stay lit after several tries, turn the gas controlknob to “OFF” and call your service technician or gas supplier.5) Tu rn gas control knob counterclockwise to “ON”.6) Us e rocker switch to operate main burner.DO NOT REMOVE THIS INSTRUCTION PLATEFOR YOUR SAFETY READ BEFORE LIGHTINGA) This appliance has a pilot which must be lighted by hand, following the instructions below exactly.B) BE FORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier thanair and will settle on the floor.WHAT TO DO IF YOU SMELL GAS- Do not try to light any appliance- Do not touch any electric switch, do not use any phone in your building- Immediately call your gas supplier from a neighbors phone. Follow the gas supplier’s instructions.- If you cannot reach your gas supplier, call the fire department.C) Us try torepair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.D) Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance andto replace any part of the control system and any gas control which has been under water.E) Thisappliance needs fresh air for safe operation and must be installed so there are provisions adequate combustion + ventilation air.918-474bOFFWARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage,or additional information consult a qualified installer, service agency or gas supplier.LIGHTING INSTRUCTIONSTO TURN OFF GAS APPLIANCETHERMOPILEELEMENTTHERMO-ELECTRIQUEPILOT BURNERVEILLEUSE1/NFPA 54, or Natural Gas and Propane Installation Codes, CSA B149.1. (Australia: A S5601-2004, New Zealand: NZS 5261)FOR UNITS NOT EQUIPPED WITH ELECTRIC SPARK:. Keep burnerappliance.STOP! Read the safety information above on this label.FOR ALL PROPANE UNITS ANDUNITS EQUIPPED WITH ELECTRIC SPARK BOXES:1) Push in gas control knob slightly and turn clockwise to“OFF”. Knob cannot be turned from “PILOT” to “OFF” unlessknob is pushed in slightly. Do not force.1) Turn off the flame switch.2) Push in the gas control knob slightly and turn clockwise to “OFF”. Do not force.3) Turn off all electric power to the appliance if service is to be performed.You may shut off the pilot during prolonged non use periods to conserve fuel.l