Regency P48-LP Owners & Installation Manual

Regency P48-LP Owners & Installation Manual Manual pdf 25 page image

Regency P48 Zero Clearance Direct Vent Gas Fireplace 25Read the instructions below carefully and refer to the diagrams.If logs are broken do not use the unit until they are replaced.Broken logs can interfere with the pilot operation.The gas log kit (Part # 370-930) contains the following pieces:a) 02-83 Center Cross Log 902-338b) 02-84 Right Side Cross Log 902-339c ) 02-85 Front Left Side Log 902-340d) 02-86 Front Right Side Log 902-341e) 02-87 Left Side End Log 902-342f ) 02-88 Rear Log 902-343g) 02-89 Middle Right Side Log 902-344h) 02-90 Right Side End Log 902-345i) Embers (Lava) 902-154h) Vermiculite 902-1791) Carefully remove the logs from the box and unwrap them. The logsare fragile, handle with care - do not force into position.3) Line up the two holes on the underside of Log 02-88 with the 2 pinsat the rear of the grate and position into place.4) Place Log 02-85 on the front left side of the burner. Position the rightend of the log into the pin on the burner and rest the left end of thelog between the 1st grate post and the front tab.02-8402-8302-8502-8602-8702-88 02-9002-89The "02" reference numbers (i.e. 02-83) are moldedinto the rear of each log.Pins02-8802-85Pin1st Grate Post02-8502-8802-86PinsTab5) Line up the two holes on the underside of Log 02-86 with the 2 pinson the right side of the burner and position into place.INSTALLATIONLOG SET INSTALLATION02-882) Sprinkle the vermiculite all over the top of the base brick panel.