Regency P48 Zero Clearance Direct Vent Gas Fireplace4This is a copy of the label that accompanies eachP48-NG and P48-LP Zero Clearance Direct VentGas Fireplace. We have printed a copy of thecontents here for your review. The safety labelis located on the front inside base of the unit,visible when the bottom louver is open.NOTE: Regency units are constantly being im-proved. Check the label on the unit and if thereis a difference, the label on the unit is the correctone.SAFETY LABELCopy of Safety Decal for P48-NG and P48-LPFor the State of Massachusetts, installationand repair must be done by a plumber orgasfitter licensed in the Commonwealth ofMassachusetts.For the State of Massachusetts, flexibleconnectors shall not exceed 36 inches inlength.For the State of Massachusetts, the appli-ances individual manual shut-off must be at-handle type valve.APPAREIL FONCTIONNANT AU GAZ PROPANECONCU POUR ETRE POELE: Mod le P48-LPPression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonéé é ééééCalorifiqueCalorifiquel'altitudeDO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE TIQUETTEÉ240NATURAL GAS: Model P48-NGMinimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputAltitudeLPROPANE: Model P48-LPMinimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputLAltitudeDOOR SEAL: Pleasecheck that the door isproperly sealedFPI Fireplace Products International Ltd. Delta, BC, CanadaMinimum Clearances to Combustibles/Degagement Minimum De Materiaux CombustiblesSerial No./ No de serie918-178b5" WC(1.25 kPa)3.8" WC(0.95 kPa)1.1" WC(0.27 kPa)# 27 DMS29,000 Btu/h (8.49 kW)0-4500 ft/pi (0-1372 m)51,000 B (14.94 )tu/h kW12" WC(3.00 kPa)11" WC(2.74 kPa)2.9" WC(0.72 kPa)# 47 DMS26,000 Btu/h (7.61 kW)48,000 B (14.06 )tu/h kW0-4500 ft/pi (0-1372 m)APPAREIL FONCTIONNANT AU NATURAL GAZCONCU POUR ETRE POELE: Mod le P48-NGPression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonl'altitudeéé é ééééCalorifiqueCalorifiqueMAY BE INSTALLED IN MANUFACTURED (MOBILE)HOMES AFTER FIRST SALE.Listed:Certified for/Certifi e pour:Tested to:Report No.VENTED GAS FIREPLACE HEATERCANADA and U.S.A.476-3059100 (June 2004)éGas-Fired Appliances For Use At High Altitudes CAN/CGA-2.17-M91,Vented Gas Fireplace Heaters ANSI Z21.88b-2003/CSA 2.33b-2003Made in Canada/ Fabrique au Canada(See Instruction Manual for Detailed Instructions.)Model/Modele:P48-NGModel/Modele:P48-LP0" Clearance tocombustibles from:Mantel Clearances from Top:Side Wall Clearancefrom Side FacingAlcove Clearances:Minimum Vent Clearances:Top, sides, bottom and rear of unit(A) Min. 8" (203mm)B) 6"Max. Depth 36" (914mm)Min. Width 60" (1524mm),Min. Height 80" (2032mm)Horizontal Top 2-1/2" (64mm)Horizontal SideHorizontal Bottom 1-1/2" (38mm)1-1/2" (38mm)B B39”CeilingWallWallAVENTING:For Manufactured Home Installation: This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and Manufactured HomeConstruction and Safety Standard Title 24 CFR, Part 3280, or the current Standard for Fire Safety Criteria for Manufactured Home Installations, Sites, and Communities ANSI/NFPA 501A, and withCAN/CSA Z240 MH Mobile Home Standard in Canada. This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located,manufactured (mobile) home where not prohibited by local codes. See owner’s manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used.This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installations Codes,CSA B149.1.Not for use with solid fuel. This vented gas fireplace is not for use with filters.