Regency PTO30-NG1 Owners & Installation Manual

Also see for PTO30-NG1: Owners & installation manual

Regency PTO30-NG1 Owners & Installation Manual Manual pdf 33 page image

Regency Plateau® PTO30-1 Outdoor Gas Fireplacee | 3333|maintenanceVALVE ASSEMBLY REPLACEMENT1. Turn off gas supply2. Remove the pilot shield.3. Remove glass crystals, garden stones and log set, if installed.4. Locate and remove 9 screws to remove the burner tray.7. Turn off gas supply and remove flex connection at valve.8. Remove orange EV1 wire connected to the gas valve.9. Remove green EV2 wire connected to the gas valve.10. Remove 8 screws securing valve assembly.11. Lift valve assembly up and out.12. Remove both yellow/green ground wires from valve and valve bracket.13. Replace valve assembly gasket if necessary.14. Rotate HI/LO modulating valve all the way to the left for HI position.15. Install new valve assembly and reverse steps 11-1.16. Test gas connections for leaks.Turn the unit off and allow to cool to room temperature.5. Lift burner tray off.6. Remove 6 screws on valve access cover.