Regency ® E33S-1 Sunrise Gas Insert16INSTALLATIONUse the FPI Remote Control Kit approved forthis unit. Use of other systems may void yourwarranty.The remote control kit comes with a hand heldtransmitter, a receiver and a wall mountingplate.1) Choose a convenient location on the wallto install the receiver and the receptaclebox (protection from extreme heat is veryimportant). Run wires from the fireplace tothat location. Use Thermostat Wire Table.2) Connect the wires as per the wiring diagramsbelow.CAUTIONDo not connect the millivoltremote control wiresto the 120V wires.3) Install 3 AAA alkaline batteries in transmitterand 4 AA alkaline batteries in the receiver.Install the receiver and its cover in the wall.Switch the remote receiver to "remote"mode. The remote control is now readyfor operation. Refer to Remote manual forcomplete details.HILOOFFONPILOTTP THTo wall switch,remote controlor thermostatTo thermopileTHTPFor PROPANE Units and Units Equipped with DC Spark Boxes**For installation of the DC Spark Box refer to the LP Conversion instructions in this manual.INSTALLATIONThermostat Wire TableOPTIONAL WALLTHERMOSTATA wall thermostat may be installed if desired,follow the wiring diagram. Note: the wires areconnected to the "TH" on the gas valve. Usethe table below to determine the maximum wirelength. FPI offers an optional programmablethermostat but any 250-750 millivolt rated non-anticipator type thermostat that is CSA, ULC orUL approved may be used.It is recommended that the thermostat beinstalled on an interior wall.CAUTIONDo not connect the millivoltwall thermostat wiresto the 120V wires.OPTIONAL REMOTECONTROLRecommended Maximum Lead Length(Two-Wire) When Using WallThermostat (CP-2 System)Wire Size Max. Length14 GA. 50 Ft.16 GA. 32 Ft.18 GA. 20 Ft.20 GA. 12 Ft.22 GA. 9 Ft.