Regency Sunrise Gas Fireplace L676S-NG1 Owners & Installation Manual

Also see for L676S-LP1 Sunrise: Specification sheet

Contents

Regency® L676S Direct Vent Gas Fireplace14INSTALLATIONINSTALLATIONSIDE NAILING STRIPSThe side nailing strips come attached to the unit.There are 2 plates on each side, one on the topand bottom that can be folded out as required.UNIT ASSEMBLYPRIOR TOINSTALLATIONThe Top Facing Support, the Side Nailing Stripsand the 2 Top Standoffs must be correctlypositioned and attached to the top before unitis slipped into position.TOP STANDOFF ASSEMBLYThe top standoffs are shipped in a flat positionand must be folded into shape and attached.1) Remove the standoffs from the fi replacetop.2) Take each standoff and bend into the correctshape. Bend up at the bend lines until thescrew holes in the standoff and the pre-punched screw holes on the fi replace topline up.3) Attach the standoff securely to the topwith 2 screws per standoff (on oppositecorners). Side Nailing Strips shown folded out.FINISHING TEMPLATEIn order to maintain a clean face; the L676Sallows for a 1/8” in overlap of fi nishing material,such as rock or tile, on both the left and righthand sides of the unit (top and bottom sides donot allow for an overlap), this overlap must notbe exceeded or the glass door will no longeropen properly.Non-combustible wall board is installed up to thefl anges on all sides of the unit. When installingany additional facing material use the FinishingTemplate (included with the unit) to ensurethat the finishing material does not exceed theallowable overlap.Left Side FlangeFinishingTemplateVENTINGINTRODUCTIONThe L676S uses the "balanced flue" technologyCo Axial system. The inner liner vents productsof combustion to the outside while the outer linerdraws outside combustion air into the combustionchamber thereby eliminating the need to useheated room air for combustion and losing warmroom air up the chimney.Note: These flue pipes must not be connectedto any other appliance.The gas appliance and vent system must bevented directly to the outside of the building,and never be attached to a chimney serving aseparate solid fuel or gas burning appliance.Each direct vent gas appliance must use it's ownseparate vent system. Common vent systemsare prohibited.The Finishing Template uses two magnets toattach itself to the fl ange on the left or rightside of the unit (see diagram below). Install thefacing material up to the outside edge (whenfacing the unit) of the fi nishing template. Thistemplate may be discarded after the facingmaterial has been installed.