Regency U41-LP3 Owners & Installation Manual

Also see for U41: Owners & installation manual

Contents

11Regency U41-3 ULTIMATE Gas Fireplace InsertINSTALLATIONTabsScrewsRightSideTopHingedLouvers3) Using the trim clips provided, join the left sidegold trim (the one with the ON/OFF switchand variable speed FAN switch) to the topgold trim. See diagram 2. Repeat this stepfor right side.8) Fan Switch wires: Connect the plug endfrom the fan switches to the matching plugfrom the unit. See Diagram 5. Make surethe plugs are pushed together as far as theycan go. Push the connection into the holein the side of the insert so it is locked intoplace.9) ON/OFF wires: Hook up the ON/OFF wiresto the switch on the left side trim. Diagram5.Trim Clipstighten topscrew onlyRear ViewDiagram 3Diagram 4Diagram 5FACEPLATE AND TRIMINSTALLATIONHint: Before doing the faceplate installation,leave the Insert out approximately4" so wires may be hooked up moreeasily.1) Lay the faceplate panels flat, face down onsomething soft so they don't scratch.2) Take the top faceplate and align the holes init with the holes in the side panels. Attach,using the screws provided. See diagram1.Diagram 1Diagram 2shut off the supply of gas within 5 - 10minutes. Tampering with the switchcan result in carbon monoxide (CO)poisoning and possible death.If the heater turns off because of lackof draft during the spillage test, checkfor the cause and if necessary, seekexpert advice.The thermally actuated safety switchwill automatically reset after it hasreduced in temperature. The switchwill continue to cycle until the draftproblem is corrected. DO NOTBYPASS OR DISCONNECT THISSWITCH.Note: The holes in the top panel are slightlylarger than the holes in the side panelto facilitate easier installation.Hint: Don't tighten the screws down completelyat this point, first do a trial fit to the unit. Makeany necessary adjustments and when it fitsproperly then tighten down the screws.4) Place the trim on the assembled faceplatepanels, aligning the wires from the switcheswith the notch in the left side faceplatepanel.The power cord should be run behind thefaceplate panel.5) Push the Regency logo plate into the twoholes in the bottom left corner of the face-plate.6) Secure the brass trim to the faceplate bydrilling a 1/8" hole through into the faceplateside flange, using the hole in the brass trimas a guide. Now fasten with the two brassplated screws provided.7) Lift the assembled faceplate up and over thetop of the insert and then lower it down so thefaceplate tabs are in line with the faceplatebrackets. See diagram 3. Once everythingis properly lined up you can tighten the 4screws on the faceplate brackets. Seediagram 4.Note: If you are making custom face-plates,you must use the faceplate louvers.Failure to do so will void the certifica-tion on your unit. The faceplate lou-vers can be purchased separately.