7Regency U41-3 ULTIMATE Gas Fireplace InsertMATERIALSREQUIREDNo electrical power supply is required for thegas control to operate. A 120 Volt AC powercord is hooked up to the fan switch and blower.Plug 3 wire cord into a suitable receptacle. Donot cut the ground terminal off under anycircumstances.When connected with 120 volts, the appliancemust be electrically grounded in accordancewith local codes, with a current version of CSAC22.1 (in Canada) or in the absence of localcodes, with the National Electrical Code ANSI/NFPA 70-1987.Note: This unit is equipped with a heat sen-sor thermodisc which will prevent theblower from operating until the unitreaches the correct temperature.INSTALLATIONCHECKLISTThe Regency Gas Insert is installed as listedbelow.1) Unit Location - check Clearances to Com-bustibles.2) Make the gas connections and electricalconnection for fan and vent spill switch.3) Install the flue or liner to the sliding drafthood.4) Install Venting. Slide the unit into the fire-place and level. Attach draft hood to theinsert.5) Test gas pressure. Check aeration.6) Test for flue spillage.7) Assemble and install the faceplate andtrim.8) Install the log set.9) Install Doors.10) Install Remote Control & Wall Thermostat11) Explain controls to the homeowner.Final check: Before leaving this unit with thecustomer, the installer must ensure that the ap-pliance is firing correctly. This includes:a) Clocking the appliance to ensure thecorrect firing rate.b) Adjusting the primary air, if required,to ensure that the flame does notcarbon.c) Ensuring that the appliance is ventingcorrectly.INSTALLATIONCLEARANCESIGJHADBEFCTop ViewClearances to CombustiblesFrom UnitSides A 7.5" / 190 mmCeiling B 35" / 890 mmMantel C(My) 11 / 280 mmFrom SurroundSides D 2" / 50 mmCeiling E 25.5" / 650 mmMantel F 3" / 75 mmMin. Alcove Width J 48" / 1120 mmMantel Depth G(Mx) 7.5" / 190 mmFacing (Mantel Leg)Side* K 1" / 25 mmTop L 1" / 25 mm*Max. width of 1" at 1" from surround, calculateMinimum Fireplace ClearancesThe minimum fireplace clearances for theRegency gas fireplace insert are shown in thefollowing diagrams:depth at 45 o as shown in the diagram.