Regency U41-LP3 Owners & Installation Manual

Also see for U41: Owners & installation manual

Contents

13Regency U41-3 ULTIMATE Gas Fireplace InsertINSTALLATIONThermostat Wire TableOPTIONAL WALLTHERMOSTATA wall thermostat may be installed if desired.Connect the wires as per the wiring diagrams onpage 13. Use table on this page to determinethe maximum wire length:Note: Preferable if the thermostat is installedon an interior wall.Regency offers an optional programmablethermostat but any 250-750 millivolt rated non-anticipator type thermostat that is CSA, ULC orUL approved may be used.CAUTIONDo not connect the millivoltwall thermostat wiresto the 120V wires.OPTIONAL REMOTECONTROLUse the Regency Remote Control Kit approvedfor this unit. Use of other systems may voidyour warranty.The remote control kit comes with a hand heldtransmitter, a receiver and a wall mountingplate.1) Choose a convenient location on the wallto install the receiver and the receptaclebox (protection from extreme heat is veryimportant). Run wires from the fireplace tothat location, use Thermostat Wire Table.2) Connect the wires as per the wiring diagramabove.CAUTIONDo not connect the millivolt re-mote control wires tothe 120V wires.3) Install 3 AAA alkaline batteries in transmitterand 4 AA alkaline batteries in the receiver.Install the receiver and its cover in the wall.Switch the remote receiver to "remote"mode. The remote control is now ready foroperation.FINAL CHECKBefore leaving this unit with the customer, theinstaller must ensure that the appliance is firingcorrectly. This includes:1) Clocking the appliance to ensure the cor-rect firing rate (rate noted on label) at 15minutes.2) If required, adjusting the primary air to ensurethat the flame does not carbon. First allowthe unit to burn for 15 min. to stabilize.CAUTIONAny alteration to the product that causessooting or carboning that results in damageto the exterior facia is not the responsibilityof the manufacturer.3) Ensuring that the appliance is venting cor-rectly. See page 8.14 GA.16 GA.18 GA.20 GA.22 GA.50 Ft.32 Ft.20 Ft.12 Ft.9 Ft.Recommended Maximum Lead Length(Two-Wire) When Using WallThermostat (CP-2 System)Wire Size Max. Length