Regency liberty LRI6E Owners & Installation Manual

Also see for horizon HRI6E: Owners & installation manual Owners & installation manual

Contents

26 | LRI6E / HRI6E Direct Vent Gas Insert|26 installationLRI6E LOG SET INSTALLATION919-415 08/05/144. Place Log 2 on the burner and rest against Log 1 as shown below.5. Place Log 3 near the end of Log 2, rest the indent in Log 3 into theprofile in the burner as shown below.3. Place Log 1 so it is positioned perpendicular to the floor of the burner- see belowLog 1 in positionLog 2 in positionRead the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,1 Rear Centre Log2 Left Side Log3 Left Front Cross Log4 Right Center Log Piece5 Right Front Log6 Right Upright LogScrew LocationsTop Bracket 123A top bracket must be installed prior to installing the log set.1. Loosen 3 screws on the bottom bracket (see below for location).2. Slide the top bracket over the screws, retighten the screws.612 3 4 51LOG INSTALLATIONLRI6E