Chapter 3: Installing the V-Switch 3000 3-7The V-Switch 3000 supports up to four storage ports in any combinations inpairs of the following:Table 3-2: Storage Port Connection TypesFC C ONNECTOR LENGTHFIBRE C HANNEL 1 G BIT/2 G BIT NL_ PORT ORN_ PORT OF EITHER : SHORT- WAVE LASER FOR MULTIMODEFIBERUP TO 550 M LONG- WAVE LASER FOR SINGLE-MODEFIBERUP TO 10 KM C OPPER (1 G BIT) UP TO 25 MYour exact portconfiguration willdepend on your V-Switch 3000 orderspecifications.SCSI ULTRA 3 LVD 160MB/ SEC 68 PIN PORT UP TO 12 MThere are four storage ports LEDs, labeled FC/SCSI 1, 2, 3 &4, on the front rightof the V-Switch 3000 for up to four storage ports.10217Storage Port LEDsFigure 3-5. V-Switch 3000 Storage Port LEDsNetwork Port ConnectionsThe network ports, labeled Eth 1, 2 & 3, are located on the front right of the V-Switch 3000. Use the 1Gb Ethernet ports to connect to the network or directlyto the host station.Each network port has both a fiber optic and copper connector but only onecable, either fiber optic or copper, can be connected to each port. To connect afiber-optic cable you need a Small Form Factor Package (SFP) opticaltransceiver to couple to the fiber optic cable and insert into the network SFPport. Please refer to Figure 3-6.
