SaMASZ KDT 180 Operator's Manual

Also see for KDT 180: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Contents

Operator’s manual Rear disc mowersKDT- 17 -N-149 N-187N-29N-05N-16N-32N-01 ; N-02 ; N-03 ; N-04N-06 ; N-07 ; N-23 ; N-48N-49 ; N-50 ; N-117N-167 ; N-168 ; N-204N-205 ; N-206 ; N-224N-109N-14; N-15N-63 ; N-162N-40N-09N-213N-201N-40Fig. 7b. Placement points of warning signs on the mower with tine/roller conditionerCAUTION:Any spare part used for repair of the mower should have all warning decalsprovided by the manufacturer.5. OPERATIONWARNING:Before beginning to use this machine, do the following:- Read manual, especially safety precautions in section 4.- Make sure you are familiar with all controls and functions.- Make sure all safety devices are in place and working. Fix or replace if notworking or damaged.- Replace protective cover if damaged.5.1. Attaching the mower to the tractorWARNING:- Only hitch and unhitch machine on a flat surface with compact dirt.- Keep everyone away from area between mower and tractor.- Be careful near link road zone of tractor's rear power lift. Contains sharp parts.Mower’s frame is adjusted to be attached to the tractors with 3-point-linkage (Fig. 8). The mowerhas been attached, adjust (on the flat ground) the mower’s position by means of top S and lower Wlinks (Fig. 8). The cutterbar should lean towards the driving direction. Lower links W should beconnected to 3-point linkage frame pins A. Support chain L holds up mower’s linkage frame. Insertand tighten the safety pins into the pin holes and make sure that they are well locked. Connecthydraulic hose to tractor’s hydraulic connector.