SaMASZ KDT 180 Operator's Manual

Also see for KDT 180: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Contents

Operator’s manual Rear disc mowersKDT- 30 -6.5. 3-point linkage support chainFig. 26. Support chainSupport chain is used to ensure 3-point linkage frame of the mower is always at the sameheight, to set the mowing unit parallel to the ground and to relieve the hydraulic lift of the tractor.When connecting mower to the tractor, the hanger plate A of support chain should be disconnectedfrom chain and put on the pin B of upper link (Fig. 26a). Then the mower has to be lifted withhydraulic lift about 1'4" high (Fig. 26b). The support chain is then connected to the hanger plate A,so that is tensioned when the mower is in its working position. If the 3-point linkage frame is morethan 1'4" above the ground, adjust the chain.6.6. Adjusting the space between tine conditioner’s mask and its shaft(Models: KDT 220 S and KDT 260 S(SL))Depending on size and thickness of the mowing grass, there may be a necessity to adjustthe mask of the conditioner. The higher and thicker grass, the bigger the space betweenconditioner’s mask and its shaft should be. Proper adjustment should be based on the experience, inorder not to block the conditioner and not to activate the friction clutch of PTO shaft. The way howthe mask is regulated is shown in Fig. 27.Fig. 27. Adjusting tine conditioner’s maskb)~1'4"ABa)+-