Saeco 10000241 Operating And Maintenance Manual

Saeco 10000241 Operating And Maintenance Manual Manual pdf 30 page image

27ERROR CODESGUIDE MESSAGE THAT APPEARS HOW TO REMOVE THE MESSAGEout of service (xx)restart to fix…Where (xx) identifies an error code.Turn off and after 30seconds turn the machine on again to restore normal operation.If the problem persists, call Saeco or an authorized servicecentre and give the code (xx) shown on the display.close coffee bean lid Close the coffee bean lid to be able to make a beverage.fill container wth coffee Put coffee beans into the bean hopper.insert the brew group Insert the Brew Group in its place (see page 26).insert grounds drawer Insert the coffee grounds drawer.empty grounds This preliminary warning does not stop the machine fromfunctioning. Proceed until the next message appears.empty grounds drawer Remove the grounds drawer and dispose of the used coffeegrounds (see page 25 steps 1 and 2).Note: The grounds drawer must be emptied only when themachine requires it and when the machine is turned on. Ifyou empty the drawer with the machine turned off it will notreset the count of cycles.close door In order for the machine to operate, the side service door mustbe closed.fill the water tank. The tank must be removed and refilled with fresh drinking water.empty drip tray Open the side service door and empty the drip tray locatedunder the Brew Group.WARNING: WHENEVER THIS MESSAGE APPEARS, BESURE TO EMPTY THE COFFEE GROUNDS DRAWER ASWELL.change the filter The water filter must be replaced in the following cases:1. 60 litres of water have been dispensed;2. 60 days have passed since its installation;3. 20 days have passed after the machine’s last use.Note: this message only appears when the filter alarm functionhas been set to “on” (see page 19, menu 2.4).carafe missingmilk island missingThe steam knob has been turned to the position and eitherthe Milk Island has not been installed or the carafe is notpositioned correctly. Install the Milk Island or position the carafecorrectly.Otherwise, turn the knob until it is in the rest position ( ).descale A descaling cycle must be performed on the machine’s internalcircuits (see page 22).stand-by… Press the button.