Saeco HD8914 Instruction Manual

Also see for HD8914: Instruction manual Owner's manual Instruction manual Instruction manual Quick start guide

10ENGLISHInserting phase> If necessary, insert the suction tube in the milk frother.> Insert the milk frother in the steam wand seat, until it locks in place.Burning hazard! If the machine has been recently used the steam wand could be hot.The rubber grip on the steam wand must be properly inserted, without going beyondits seat, otherwise the milk frother does not operate correctly and no milk is sucked.> Insert the suction tube in the milk container.Waiting phaseIt is possible to hold on the suction tube in the milk frother top.Removing phase> Pull the milk frother out to remove it from the steam wand.6.3 Milk- and coffee-based preparationsTo prepare a good cappuccino, use cold milk (~5°C / 41°F) with a protein contentof at least 3%. It is possible to use whole and skimmed milk, soy milk and lactose freemilk, according to personal taste.6.3.1 Brewing a milk-based product> Fill 1/3 of a container with cold milk.> Place a cup under the milk frother.Burning hazard! At the beginning of each product brewing, milk or steam sprays mightbe present.The milk frother must be installed and the suction tube inserted in the milk container.One frothed milk> Press the MILK FROTH button to start frothing the milk.Wait for the necessary pre-heating time. The machine dispenses frothed milk in thecup.> To stop dispensing, press the OK button. It will take a few seconds before the machinestops dispensing completely.The machine automatically stops dispensing if no button is pressed for 3 minutes.It is immediately possible to brew coffee or dispense hot water.> To prepare a cappuccino, brew an espresso or an espresso lungo, as indicated at the“6.1 Coffee-based preparations” chapter.When finished it is necessary to dispense a small amount of hot water into a container,as described in the “7.4.1 Milk frother cleaning cycle” chapter.6.3.2 Adjustment of milk length in the cup during preparationIt is possible to adjust the quantity of product brewed according to one’s taste and thesize of the cups. This function makes it possible to change the default setting for thequantity of milk dispensed in the cup.The milk frother must be installed.Frothed milk length> To adjust the milk length, keep the MILK FROTH button pressed until the MEMOsymbol is displayed, then release the button.> Wait for the necessary pre-heating time.The machine is in the programming stage andis starting to dispense the frothed milk.> Press the OK button as soon as the desired quantity has been reached.Now the button is programmed: every time it is pressed, the machine will brew theproduct in the quantity just set. After the product has been brewed, the machine goesback to the main menu.MEMOMEMOIncanto_AMF_EN-IT-DE_Rev01.indb 10 27/03/15 09:58