Saeco Lirika User Manual

Also see for Lirika: Operating instructions

Contents

• 42 •Machine Installation - Service Provider ManualThe menus should be PASSWORD-protected.The PASSWORD will not be requested if set on thedefault value (0000). It should be changed upon1st use to prevent unauthorised access. After this change,it should be entered again at each access, every time thedisplay shows:0 0 0 0Refer to section 10.4 on how to set the PASSWORD.10.2 Programming ControlsWhen the machine menus are accessed, the buttons on the keypad take on new functions." " "change" button (18) This button allows the parameters to be changed when they are displayed." " "change" button (20) This button allows the parameters to be changed when they are displayed.“ ” button (24) (Scroll parameters / OK) This button allows the user to:1 scroll through the menu pages;2 confi rm the parameter/value after changing it." " "ESC" button (22) This button allows the user to exit without changing the edited or selected param-eter.Note: Press it repeatedly to exit programming mode.To enter the password:1 Press the “ ” (18) or “ ” (20) button to set the desirednumber.2 Press the “ ” button (24) to move on to the next number(when it gets to the end, it will start again from the beginning).3 Repeat steps 1 and 2 until the set password has been entered.4 Press the “ ” button (21) to confi rm and to access pro-gramming mode.Note: If the PASSWORD is forgotten, you can resetit by entering a PUK code. You have to request thePUK code to the Saeco service centre, who will guide youthrough the procedure.