7Englishfor the coffee to flow. To stop the flow, press any of thepads. If the coffee flows too slowly, the grinding level hasto be increased. If the coffee flows too quickly, thegrinding level has to be reduced. Important: Prepare 2coffees at least, after this operation, in order to enjoy thegrinding variation.Fig. 8024810121416 1868-CUPLEVELADJUSTMENTFig. 9024810121416 186CLOSE OPEN• When the pre-grinding program is activated, the machine grinds the dose for the next serving whiledispensing the coffee.This allows the next coffee to be dispensed in a shorter time as the coffee dose is ready.• To activate the pre-grinding program, press the and the pad simultaneously. Confirm bypressing the pad within 5 seconds.• The slow blinking of the 5 leds of the coffee pads indicates that the pre-grinding program has beenactivated.• To exit this special program mode repeat the a.m. procedure.• Attention: By activating the pre-grinding program, the coffee dose remains in the machine until thenext coffee is dispensed.In case the machine does not work for a certain period (for example at night or on the week end) thepre-ground coffee dose may loose its flavour and occasionally the doser may not function properly.We therefore recommend that the pre-grinding program be activated only when actually required (forexample rush hours) and to exit the program every evening taking care to dispense at least 1 cup ofcoffee after having deactivated it for the purpose of discharging the doser.9-PRE-GRINDINGADJUSTMENT(onlyProfimatDELUXE)• Turn the main switch to “0”.• Turn the main switch to”1”while pressing the and thepad simultaneously. When the led is blinking theprogramming procedure is activated.• Press the pad that has to be programmed. Press it againwhen the desired cup level has been reached. Follow thesame procedure for setting all selection buttons.• Important: The quantity for 2 cups( , )ofcoffee will be automatically adjusted by setting theselection button. for 1 cup.• Turn off the machine by means of the main switch to exitthe program mode.• Attention: By entering the program mode, it’s possible tochange the level of only one of the pads without having tochange them all.