Saeco Syntia Service Manual

Also see for Syntia: Operating instructions Operating instructions Service manual Quick start guide

SYNTIA 05 SERVICE MODESaeco International Group Rev.01 February 2010 Page 5 / 075.1.2 Focus test modelev. pos.knob symbol buttonstatus press functionL1 Initial LED status at level 1If the screen does not change from the initial status,replace the interface card and/or the JP21 flat cable.PRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UPOperational check - keysMEMOMEMOlev. pos.knob symbol button functionL2 Initial LED status at level 2Remove watertankIf the LED does not turn on, check thecapacitive sensor and the JP22, JP23 wiringOpen servicehatchIf the LED does not turn on, check thehatch microswitch and the JP16 wiringRemove dregsdrawerIf the LEDS do not turn on, check themicroswitch and the JP16 wiringRemove the brewgroupIf the LED does not turn on, check thegroup microswitch and the JP14 wiringIf the LEDS do not turn on, checkthe knob card and the JP21 wiringIf the LED does not turn on, check theknob card and the JP21 wiringPRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UPOperational check -microswitches and sensors MEMOMEMOMEMOMEMO1 3To enter Test Modeposition the control knob in the hot water position1.keep the espresso coffee key pressed2.turn on the machine by pressing the 0/I button on the3.rear (espresso coffee and long coffee blink alternatively)release the espresso coffee button (you go directly to the4.1st level of the Test Mode)To go to a higher level, press the On/Off buttonMEMO MEMO2