Salus SS881ZB Installation And Quick Start Manual

Also see for SS881ZB: System guide Quick install guide

Salus SS881ZB Installation And Quick Start Manual Manual pdf 1 page image

Version 2Installation / Quick Start Guide: Embedded Door Sensor (SS881ZB)Visit www.salusinc.com for the User ManualIn the Box Tools Needed NOTE:Additional equipment may berequired due to buildingconstruction or materials, orother radio interference thatmay reduce the radio range.The open field range is 400m.Sensor w/ Battery(1x CR2, 3V Lithium)Sensor Sleeve Installation Tool(2)Drill Stickers(2)Installation/UserGuide7/8” Drill Bit Drill Rubber MalletPAIRING INSTRUCTIONS• Follow your system’s instructions to prepare to add devices to the system.• Go to where the sensor is being installed to account for any radio interference.• Pull the battery tab to start the pairing process.• When the Sensor is detected and added to the system, proceed to the Sensorinstallation.INSTALLATION INSTRUCTION• Identify the specific location for the sensor and mark thelocation with the sticker. The preferred location is in thedoorjamb on the hinge side of the door so that closing thedoor will push in the plunger. If there are obstacles beside thedoor, such as glass panels, the sensor can be mounted in thelintel above the door or in the door itself.• Drill a 7/8” hole at least 2.6” deep through the sticker, andthen remove the rest of the sticker.• Insert the Sensor Sleeve in the hole until the flange isseated on the jamb surface. If the sensor needs to beinstalled flush with the surface of the jamb, remove the flangefrom the Sensor Sleeve before inserting the sleeve.• Insert the Sensor into the Sensor Sleeve and screw theSensor into the Sensor Sleeve until the desired depth isreached. There will be clicks once the Sensor is past theminimum number of turns.• Align the front slots with the grooves in the sleeve for apositive lock.• Close the door to verify that the sensor operates properlyand the Sensor does not interfere with the closing of thedoor. Screw the Sensor in further if it interferes. If closingthe door does not trigger the Sensor, unscrew the Sensora quarter turn each time until it does trigger.REPLACING THE BATTERY(Use only Duracell DL-CR2, Rayovac RL-CR2, EnergizerEL1CR2, or GP Batteries GPCR2 batteries)• Mark the depth of the Sensor in the SensorSleeve if required.• Unscrew the Sensor from the Sensor Sleeveusing the installation tool or a coin.• Remove the battery cover and remove thebattery.• Insert a new battery into the Sensor, observingthe proper polarity.• Replace the battery cover.• Replace the sensor in the Sensor Sleeve at theoriginal depth.FACTORY RESETTING THE SENSOR• Unscrew the Sensor from the Sensor Sleeve.• Remove the battery cover and battery.• Press and hold the tamper switch while re-inserting the battery.• When the LED lights, release the tamperswitch.• The Sensor is now in pairing mode and willrespond to pairing requests.• Replace the battery cover.• Replace the sensor in the Sensor Sleeve at theoriginal depth.LED INDICATIONSSolid at power up: Initializing and checking for Factory Reset3 flashes then pause: Searching for network to join

/ 2

Related manuals for Salus SS881ZB