Samsung 5500 Series User Manual

Also see for 500 series 5: User manual User manual Quick start guide E-manual E-manual

Contents

Network Connection - WiredThere are two main ways to connect your TV to your network using cable, depending on your network setup. They areillustrated below:The Modem Port on the Wall External Modem(ADSL I VDSL I Cable TV)~ '?fY~=i;li;11 .?:JModem Cable....._---------The LAN Port on the WallLAN Cable1V Rear Panel1V Rear PanelLAN CableIP Settings~ A network speed of lower then 10 Mbps is not supported.Configuring the Network Connection - WiredMost home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networksthat support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to accessthe Internet so you don't have to enter them manually.To configure your network connection for a network that usesDHCP, follow these steps:1. Connect your TV to your network as shown in one of theillustrations above.2. Turn on your TV, press the MENU button on your remote, andthen select the Network -> Network Settings.3. Select Wired.4. The network connection screen appears and verifies thenetwork connection. When the connection has been verified,the "Internet is connected successfully." message appears.~ If your TV cannot acquire network the connection valuesautomatically or if you want to set up the connectionmanually, select IP Settings on the network connectionscreen. Set IP Mode to Manual. You must enter the IP Address, Subnet Mask, Gateway, and DNS Servermanually.~ For the detailed information, refer to "Network Settings" in the e-Manual.