Samsung 5500 Series User Manual

Also see for 500 series 5: User manual User manual Quick start guide E-manual E-manual

Contents

Plug & Play (Initial Setup)When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings, To turn onthe TV, press the POWERC) button,~ Plug & Play is available only when the Source is set to TV.~ To return to the previous step in the Plug & Play sequence, press the red button on your remote.Press the ENTER G button,Set up your network connection. Press the ENTER G button to start. If you do not knowyour network set up information or want to set it up later, select Watch TV. We suggest youskip network connection setup now and refer to "Network menu" in the e-Manual for setup requirements and instructions, and the Network Connection section of this manual (Page12). You can set up the network connection later using the Network menu.Press the .... or ~ button. Press the'" or ,. button to select Auto or Manual, and thenpress ENTER G.~ If you selected Auto, you'll select the time zone where you live next, and then selectwhether to turn DST (Daylight Savings Time) On or Off.~ If you selected Manual, you'll use the number buttons or ... or ,. button to set thedate and time. Use the .... or ~ button to move between entry fields.POWER~Press the'" or ,. button to select Air or Cable, and then press ENTER GJ. A checkappears on your selection. Select Next, and then press the ENTER G button, You cancheck both if you have both connected.~ If you selected Cable, you'll go to the Cable System screen. Use the'" or ,. buttonto select Digital or Analog, and then press ENTER G. Use the'" or ,. button to selectthe correct cable signal format - STD, HRC, or IRC - and then press ENTER [3i.Most cable systems use STD. Select the correct cable signal format for both theDigital and Analog systems, When done, select Search, and the press ENTER G.The channel search will start automatically. This can take up to 30 minutes.For more information, refer to Channel -> Auto Program in the e-Manual.~ Press the ENTER G button at any time to interrupt the memorization process .Press the .... or ~ button, and then press the'" or ,. button to selecta language. Press ENTER GJ when done.Press the .... or ~ button to select, and then press the ENTER GJbutton.• Select the Home Use mode. Store Demo mode is for retailenvironments.Selecting andmemorizing channelsSelecting the OSDLanguage. , Setting up the networkconnection"~ Enjoy your TV.If You Want to Reset Plug & Play...[S MENU!ID -> System -> Plug & Play -> ENTER G~ To change the TV's settings from Store Demo to Home Use when not in Plug &Play, press the volume button on theTV. When you see the volume in the OSD, press and hold MENU for 5 sec.