English - Upgrading the SoftwareTo keep your product up-to-date with new Digital Television features then software upgrades are periodically broadcast aspart of the normal Television signal. It will automatically detect these signals and display the software upgrade banner. Youare given the option to install the upgrade.1. Insert a USB drive containing the firmware upgrade into the WISELINK porton the side of the TV.2. Press the MENU button to display the menu.Press the ▲ or ▼ button to select “Setup”, then press the ENTER button.3. Press the ▲ or ▼ button to select “Software Upgrade”, then press theENTER button.4. Press the ▲ or ▼ button to select “BY USB”, “BY Channel” or “StandbyMode Upgrade”. Press the ENTER button.BY USB :- Preset : Insert a USB drive containing the firmware upgrade into TV.Please be careful to not disconnect the power or remove the USBdrive while upgrades are being applied. The TV will turn off and turn onautomatically after completing the firmware upgrade. Please check thefirmware version after the upgrades are complete. When software isupgraded, video and audio settings you have made will return to theirdefault (factory) settings. We recommend you write down your settings sothat you can easily reset them after the upgrade.BY Channel :Upgrades the software using the broadcasting signal.Standby Mode Upgrade :To continue software upgrade with master power on, Select On by pressingthe ▲ or ▼ button. 45 minutes after entering standby mode, a manualupgrade is automatically conducted. Since the power of the unit is turnedon internally, the screen may be on slightly for the LCD product. Thisphenomenon may continue for more than 1 hour until the software upgrade iscompleted.Alternative Software :To display the software version information.➣SetupEnergy Saving : OffPIPSoftware Upgrade ►Common InterfaceTV Side PanelUSB DriveSoftware UpgradeCurrent Version 2008/01/01_000075BY USB ►BY ChannelStandby Mode Upgrade : OnAlternative Software ----/--/--_--------ReturnEnterMove
