Samsung AH68-01850K Instruction Manual

GBMETHOD 1 Composite Video ............... Good QualityConnect the supplied video cable from the VIDEO OUT jack on the back panel of thesystem to the VIDEO IN jack on your television.METHOD 2 Component (Progressive Scan) Video ............... Best QualityIf your television is equipped with Component Video inputs, connect a component videocable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to thecorresponding jacks on your television.ï When the Progressive scan mode is selected, the VIDEO output (Yellow) andSCART output does not output any signal.NoteCONNECTIONS16Choose one of the two methods for connecting to a TV.Connecting the Video Out to TVMETHOD 1METHOD 215WIRELESS RECEIVER MODULEï When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker OUT ports on the backof the main unit.ï The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.ï For optimal listening performance, make sure that the area around the wireless receiver module location is clear of anyobstructions.ï Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.ï In 2-CH mode, no sound will be heard from the wireless rear speakers.Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver doesnot light up and the "REAR CHK" message blinks on the main unit's display.Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.With the main unit turned off, press andhold the remote control's REMAIN buttonfor 5 seconds.ï Press the button until the POWER( ) indicator lightsup blue. (The indicator will turn off in 1 second.)With the wireless receiver moduleturned on, use a ball point pen or a pairof tweezers to press the RESET buttonon the back of the unit.ï The Standby/On LED on the front panel of thewireless receiver module blinks 2 times.21Turn on the main unit.ï The Link LED of the wireless receiver module is litand the setup is finished.ï If Power Standby mode continues, repeat Steps 1 to3 above.3Cautionï Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the mainunit, some sound interruption may be heard due to interference.ï If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the samefrequency (2.4GHz) near the system, some sound interruption may be heard due to interference.ï The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment.If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not operate atall, because the radio wave cannot penetrate metal.NoteResetting Wireless CommunicationConnecting the optional Wireless Receiving AmplifierHT-Q20(1~40P)-NOR- GB 3/20/06 9:37 AM Page 18