Installation partsEnglish-32BADC BADCBADCFixing the installation plateYou can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fixingthe installation plate to a wall or a window frame, you must determine the position of the 65 mm hole through which the cable,pipe and hose pass to connect the indoor unit to the outdoor unit.When facing the wall, the pipe and cable can be connected from the:ACBD D Direction of pipe3. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameterof 65 mm so that it slants slightly downwards.• Right (A)• Left (B)• Underside_right (C)• Rear_right or left (D)Wall<20 mmPlasticAnchor4. Fix the indoor unit.If you fix the indoor unit on a wall(1) Fix the installation plate to the wall giving attention to the weight of the indoor unit.If you fix the indoor unit on a window frame(1) Determine the positions of the wooden uprights to be attached to the window frame.(2) Attach the wooden uprights to the window frame giving attention to the weight of the indoor unit.(3) Attach the installation plate to the wooden upright using tapping screws.If you fix the indoor unit on a gypsum board(1) Use stud finder to find out locations of the studs.(2) Fix the plate hanger on two studs.• If you mount the plate to a concrete wall using plastic anchors, make sure that gapsbetween the wall and the plate, created by projected anchor, is less than 20 mm.• Make sure to drill only one hole after choosing thedirection of the pipe.(Unit : mm)Model A B C D015/022/028 36 60 65 36036/045 36 120 81 36056/071/082 33 110 110 33Pipe hole (Ø65 mm) Pipe hole (Ø65 mm)1. Disassemble the cover panel as described in installation manual.2. Remove the Hanger plate from the indoor unit.(1) Unscrew 2 screws that fixes the Hanger plate to the indoor unit.(2) Push the hooks (on the bottom part of the indoor unit) up to release the installation plate from the hooks that holds it.(3) Pull the installation plate to release it completely from the indoor unit.ScrewPipe hole (Ø65 mm)