Samsung ARFSWK** Series User & Installation Manual

Contents

English-53INSTALLATION05Fixing the indoor unit in placeInsulationPipes'X' mmRubber leg'Y' mmPerform the following work on the area where gas leak test was done priory.After checking for gas leaks in the system, insulate the pipe, hose and cables.Then place the indoor unit on the installation plate.1. To minimise condensation problems, wrap foam insulation (as shown in thefigure) on a part without insulation on the end of the pipes.2. Wind the pipe, assembly cable and drain hose with vinyl tape.3. Place the bundle (the pipe, assembly cable and drain hose) in the lower partof the indoor unit carefully so it does not project from the rear of the indoorunit.4. Hook the indoor unit to the installation plate and move the unit to the rightand left until it is securely in place.Install the outdoor unit in level on a stable base to help avoid the generation of noise andvibration, especially when installing the unit close to a neighbor.If you install the outdoor unit in a place exposed to strong winds or at a height, fix it to anappropriate support (wall or ground).1. Place the outdoor unit as indicated on the top of the unit to let the discharged airout properly.2. Fix the outdoor unit in level to an appropriate support using anchor bolts.3. If the outdoor unit is exposed to strong winds, install shield plates around theoutdoor unit so that the fan can operate correctly.5. Wrap the rest of the pipe with vinyl tape.6. Attach the pipe to the wall using clamps (optional).InstallationplateConnecting wiresConnectingpipesVinyl tapeDrain hose• Make sure pipe does not move when you install the indoor unit onan installation plate.Fixing the outdoor unit in placeModel X YAR09/12CWKAR09/12DUR 602 310AR09/12BWKAR09/12CUR 612 31718/24 660 34030 690 403• Ensure the wall will be able to suspend the weight of rack andoutdoor unit;• Install the rack close to the column as much as possible;• Install proper grommet in order to help reduce noise and residualvibration transferred by outdoor unit towards wall.Outdoor unit installed on the wall by rackSoft rubber designed to cut offvibration from rack to wall.(not supplied with product)Designed to cut off residual vibrationfrom outdoor unit to rack.(not supplied with product)• Secure the rubber leg to help prevent the generation of noise and vibration.Australia_A3050_IB&IM_EN_03979A-03.indd 53 2013-10-28 17:04:02