Samsung AS09E Series User & Installation Manual

ENGLISH27Fixing the installation plateThe following connection accessories are optional. If they are not supplied, you should obtain them before installing the airconditioner.Optional accessoriesInsulatedAssembly Pipe,Ø6.35mm (1)Insulated AssemblyPipe, Ø9.52mm (1)TT 09 TTInsulated Assembly Pipe,Ø12.70mm (1)TT12/18/19TTInsulated Assembly Pipe,Ø15.88mm (1)TT24/25TTPE T3 Foam TubeInsulation (1) Vinyl Tapes (2) Drain Plug (1)Rubber Legs (4) Pipe Clamps A (3) Pipe Clamps B (3) Cement Nails (6) M4 x 25 TappedScrews (6)Drain Hose,length 2m (1) Putty 100g (1)t If these accessories are supplied, they will be in the accessory box.BADCDYou can select the direction of the drain hose depending on where you want toinstall the indoor unit. Therefore before xing the installation plate to a wall or awindow frame, you must determine the position of the 65mm hole through whichthe cable, pipe and hose pass to connect the indoor unit to the outdoor unit.When facing the wall, the pipe and cable can be connected from the:! Right (A)! Left (B)! Underside_right (C)! Rear_right or left (D)1 Determine the position of the pipe and drain hose hole as seen in the pictureand drill the hole with an inner diameter of 65mm so that it slants slightlydownwards.CAUTION Make sure to drill only one hole after choosing the direction ofthe pipe.2 Fix the indoor unit.If y x the indoor unit on a wall(1) Fix the installation plate to the wall giving attention to the weight of theindoor unit.Note If you mount the plate to a concrete wall using plasticanchors, make sure that gaps between the wall and the plate,created by projected anchor, is less than 20mm.Wall<20mmPlastic AnchorIf y x the indoor unit on a window frame(1) Determine the positions of the wooden uprights to be attached to thewindow frame.(2) Attach the wooden uprights to the window frame giving attention tothe weight of the indoor unit.(3) Attach the installation plate to the wooden upright using tappingscrews.Direction of pipe120726872(Unit : mm)Pipe hole(Ø65mm)t Fix the installation plate without inclining to one side.t Make sure that a wall can withstand the weight of the product. If you install the product in a place where it is notstrong enough to withstand the product weight, the unit could fall and cause injury.09/12 TTTT170728572(Unit : mm)Pipe hole(Ø65mm)**18/19/24/25**