Samsung CLP-510/XBH Service Manual

Also see for CLP 510N - Color Laser Printer: Driver manual Manual Product guide Service manual Brochure & specs

Contents

5-12System OutlineSamsung ElectronicsService Manual5.2.3 Ready1) Host interface is monitored for print commands2) Heat control* Target temperature (165°C)* Every 40 seconds, temperature value for the previous 250ms is read and a proportional controlprocess is carried out3) This is the standby mode entered after warm-up or after completing a print job.4) System Error check5) Power save state is entered after timeout> Wakeup condition* When a "wakeup" order is received* When a cover is opened and then closed* When the level of the paper empty sensor changes.> Heat lamp is off5.2.4 Pre-PrintThis is the preparation stage before processing a printing job and after receiving a print command from a host.1) Start LSU* Run Scanning motor* Check motor ready* Turn LD on2) Start BLDC motor, Eraser/PTL on* Run main motor* Check lock signal* Run developer roll motor* Check lock signal3)Turn High Voltage On* Charger on* Developer high voltage off4) Cleaning* OPC cleaning (Mechanical motion)* ITB cleaning5) Jam check6) Motor Unlock Check7) Check and Set a High Voltage Condition (T1, T2, Charger)8) Initialize Printing Parameters* Paper size, copies, cassette ...* Image pixels, image times, y-offset, x-offset* Flags9) Check Print mode* Color print mode:- Except legal & OHP/Legal/OHP- Simplex/Duplex* Mono pint mode: Simplex/Duplex/OHP