3.1 <Getting Started>3 Getting StartedThis chapter gives you step-by-step instructions for setting up themachine.This chapter includes:• Setting up the hardware• Setting up the network• Installing the software• Printer's basic settingsSetting up the hardwareThis section shows the steps to set up the hardware which is explainedin the Quick Install Guide. Make sure you read Quick Install Guide andcomplete following steps.1 Select a stable location.Select a level, stable place with adequate space for air circulation.Allow extra space to open covers and trays.The area should be well-ventilated and away from direct sunlight orsources of heat, cold, and humidity. Do not set the machine close tothe edge of your desk or table.Printing is suitable for altitudes under 2,500 m (8,200 ft). Refer tothe altitude setting to optimize your printing. See page 3.4 for moreinformation.Place the machine on a flat and stable surface for not letting it tiltmore than 5 mm (0.2 inches). Otherwise, it may affect the printingquality.Allow a flat surface area of 5 mm (0.2 inches) to surround all sides.2 Unpack the machine and check all the enclosed items.3 Remove the tape holding the machine tightly.4 Install both the print cartridge.5 Load paper. (See "Loading paper" on page 4.4.)6 Make sure that all the cables are connected to the machine.7 Turn the machine on.CautionWhen you move the machine, do not tilt or turn it upsidedown. Otherwise, the inside of the machine may becontaminated by toner, which can cause damage to themachine or bad printing quality.Setting up the networkYou need to set up the network protocols on the machine to use it as yournetwork printer. You can set up the basic network settings with themachine's touch screen.Note• If you want to use the USB cable, connect the cable between acomputer and you machine. Then, refer to the softwareinstallation in Software section.• For detailed information on network settings, please, refer tothe Network Printer Quick Guide, or the on-line user's guide onthe Network Utilities CD.