ŝ33Şƈ If you cannot obtain suitable exposure conditions, you can change the meteringmethod to take brighter pictures.[Multi] : Exposure will be calculated based on anaverage of the available light in the imagearea. However, the calculation will bebiased towards the centre of the imagearea. This is suitable for general use.[Spot] : Only the rectangular area in the centre ofthe LCD monitor will be metered for light.This is suitable when the subject in thecentre is exposed correctly, regardless of the back lighting.ſ If the subject is not the centre of the focus area, do not use the spot meteringas this may result in an exposure error. In this circumstance, It is better to useexposure compensation.ƈ You can select continuous shot, and AEB (AutoExposure Bracketing).- [Single] : Take one picture only- [Continuous] : Images will be taken continuouslyuntil the shutter button is released.The shooting capacity depends onthe memory.- [AEB] : Take three pictures in a series indifferent exposures: short exposure(-0.5EV), standard exposure (0.0EV)and over exposure (+0.5EV). Use the mode if it is hard todecide exposure of the object.ſ High resolution and picture quality increases file saving time, which increasesstand-by time.ſ If the [Continuous] or [AEB] sub menu is selected, the flash will be offautomatically.ſ If less than 3 pictures are available in the memory, the AEB shooting is notavailable.ſ It is best to use a tripod for the AEB shooting as the time to save each imagefile is longer and the blurring caused by camera shake may occur.[ PROGRAM mode ]METERINGMultiSpor[ PROGRAM mode ]SHOOTINGSingleContinuousAEBMetering Continuous shot