Samsung Digimax Digimax V4000 User Manual

Contents

Samsung Digimax Digimax V4000 User Manual Manual pdf 29 page image

29RECORDINGStarting recording mode1. Insert the batteries (p.17).Insert the batteries taking note of the polarity (+ / -).2. Insert the memory card (p.20).3. Close the memory card cover.4. Slide the power switch to turn on the camera.5. Select the PROGRAM mode by rotating the mode dial.6. Point the camera towards the subject and compose the image byusing either the viewfinder or LCD monitor.7. Press the shutter button to capture an image.[DELETE] message may be displayed after taking a picture.Refer to p.93 for more information about [DEL. ANSWER].Recording a still imagePROGRAM modePROGRAM modeINFORMATIONManner modePressing the power button over 2 seconds changes the buzzer and start-up sound setting toOFF, though you have set the settings to ON. If you wish to hear the buzzer sound and start-up sound, set the [SOUND] and [S.SOUND] settings in the SETUP mode to ON.There are two LED lamps (one green, one red) positioned next to the viewfinder.- If the camera is in focus when you press the shutter button halfway, the green LED willilluminate and you can take an image. If the camera can focus on the subject, theautofocus frame in the center of the LCD monitor will change from white to green.- If the red lamp illuminates, the flash can fire.- If the red lamp blinks, the flash is being charged.- When an image is being stored onto the memory card, the green lamp blinks slowly. Whenthe image data has been stored, the green LED light will go out. After the green LED lighthas gone out, you can resume taking images.NOTICEA Blinking autofocus indicator lamp means that the camera cannot focus on the subject.Should this be the case, the camera is unable to capture an image clearly.