124Starting PC modeConnecting the camera to a PC1. Turn the PC power on.2. Turn the camera power on.3. In any mode other than Voice Recording mode, pressthe MENU button.4. Press the LEFT/ RIGHT button and select the [Setup]menu tab.5. Select the [USB] menu by pressing the UP/ DOWNbutton and press the RIGHT button.6. Use the UP and DOWN buttons to select [Computer], and then press the OK button.7. Press the menu button twice and the menu will disappear.8. Connect the PC and the camera via the USB cable.- Insert the small plug of the USB cable into the camera USB connection terminal.- Insert the large connector of the USB cable into the USB port of the PC.- The plugs must be firmly inserted.If you connect the USB cable to a USB port on your PC and then turn on the power, thecamera will automatically switch to "computer connection mode".In this mode, you can download stored images to your PC through the USB cable.The LCD monitor is always turned off in PC mode.The camera status lamp will blink when the files are transferring via the USB connection.FormatDate&TimeImprintSoundUSBComputerPrinterSetupBack: Set:OKIf you selected [Printer] in Step 6, when youconnect the camera to your computer, the[Connecting Printer] message will bedisplayed on the LCD monitor and theconnection will not be established. In thiscase, disconnect the USB cable, and thenfollow the procedure from Step 2 andonward.The camera driver must be installed before using PC mode.To save battery power, it is recommended that you use an AC adapter (Optional) whenconnecting the camera to a computer.INFORMATIONDisconnecting the camera and PC : Refer to page 130 (Removing the removable disk).
