98SoundConnecting an External Device (USB)If you set the operation sound to ON, various sounds will be activated for camera startup,when button are pressed, and if there is a card error, so that you can be aware of the cameraoperation status.Setting Operation Sounds1. In any mode with the exception of Voice Recording mode,press the MENU button.2. Press the LEFT/ RIGHT button and select the [Setup]menu tab.3. Select the [Sound] menu by pressing the UP/ DOWNbutton and press the RIGHT button.4. Select a desired sub menu by pressing the UP/ DOWNbutton and press the OK button.[Sound] sub menu : Off/ Low/ Medium/ High5. Press the menu button twice and the menu will disappear.You can select an external device to which you want to connect the camera using the USBcable.Selecting an External Device1. In any mode with the exception of Voice Recording mode,press the MENU button.2. Press the LEFT/ RIGHT button and select the [Setup]menu tab.3. Select the [USB] menu by pressing the UP/ DOWN buttonand press the RIGHT button.4. Select a desired sub menu by pressing the UP/ DOWNbutton and press the OK button.[Computer] : Select this if you want to connect the camera to your PC.Refer to page 124 for instructions on how to connect the camera to your PC.[Printer] : Select this if you want to connect the camera to your printer.Refer to page 88 for instructions on how to connect the camera to yourprinter.5. Press the menu button twice and the menu will disappear.LanguageFormatDate&TimeImprintSoundOffLowMediumHighSetupBack: Set:OKFormatDate&TimeImprintSoundUSBComputerPrinterSetupBack: Set:OK
