Samsung ES7100 User Manual

4.Setting up Universal Remote with Universal Remote Code Setlf your remote controller buttons does not work, please set your remote to W mode by using the DEVICEbutton.1. To set up Universal Remote, press the SETUP button on your remote for 3 seconds. All the LEDs onthe top of your remote blink twice simulaneously.2. Press the 1 button on your remote to select a Set-top box.3. Press the number button corresponding to the porl of device connected.\ Port numbers are as follows:Enter Universal Remote Code corresponding to device you have.S For more detailed information about Universal Remote Code, refer to "Universal Remote Code Setlist" on page 21 .When done, all the LEDs on the top of your remote blink twice simultaneously.Set your remote to STB mode by using the DEVICE button, and then test your remote. lf you externaldevice is not work, try again Steps 2 to 4 by using another Universal Remote Code.S, Each time you press the number button, one of the LED blinks. You can check input result throughthe LED on the top of your remote. lf you press the button too fast, Universal Remote Code maynot input correctly.Using your remote as a Universal Remoteln Universal Remote mode, you can use your remote to control your W and STB together, your TV alone,or your STB alone. When you have set your remote to control your W and STB, cerlain buttons control theW only and certain buttons control the STB only.. Controlling the TV and STB TogetherTo control your W and STB together, press the WATCH TV button at the topcenter of your remote. The W and STB LEDs go on and off. lf the W is on, itautomatically changes to the source the STB is connected to.You can control the W and Set-Top box using the universal remote. (Forexample, press the Volume button to adjust the W volume, press thechannel button to change the STB channels, etc.)\ See the illustration to the right. When you are using theremote as a universal remote, the buttons demarcated for TVcontrol the TV only and the buttons demarcated for STB control the settop box onlY.5 Universal Remote Control can adjust TV's volume, but STB's volumecannot be adjusted. Watch STB after adjusting STB's volume toappropriate level.S To turn only the TV off, press the DEVICE button, change to TV mode,and then press the O button. To turn only the STB off, press theDEVICE button, change to STB mode, andthen press the 0 button.To turn the TV and the STB off, press the O button and hold it for twoseconds.5.6.