English-28Setting the Display optionDisplay lighting can be adjusted by following this instruction.1 Press the Settings button2 Press the , or Settings button until (Display) indicator starts to blink3 Press the SET button to set the display status- 3 seconds after setting Display function, (Display) indicator on the remotecontroller display will disappear and indoor unit display will be turned offCancelf Press the Settings button Press the , or Settings button tomake (Display) indicator blink and press the SET buttonf (Display) indicator on the remote controller display will disappear andthe indoor unit display will be turned on again• Display option cannot be set when the air conditioner is off.• If you turn off the display when the Virus doctor function is in operationwith air conditioner operation, the indoor unit display and Virus Doctorlamp will be turned off at the same time.• Operation or timer display will not be turned off by the display off function.Checking the power consumptionThis function will display the amount of electricity consumed by operating the air conditioner.When the air conditioner is operating;ARWK SeriesARUR SeriesIndoor unit display1 Press the Settings button2 Press the , or Settings button until (Usage) indicator starts to blink3 Press the SET button to check the power consumption- 3 seconds after setting power consumption checking function, (Usage) indicatoron the remote controller will disappear.- Indoor unit will display the amount of Power consumption for few seconds andthen return to usual status by displaying the set indoor temperature.- Power consumption will be calculated from the moment the air conditioner isturned on and calculated value will be reset when the air conditioner turns off.- 0.1 is the default value of the electricity consumption and 99 is the maximumvalue. Unit is in kWh.• When the air conditioner is not operating, power consumption will notbe displayed on the indoor unit display.A3050 Australia_IB&IM_DB68-05206A_EN.indd 28 2014/12/29 19:07:29